Any suggestions, other than ordering 4 mm Bowden Couplings?

Второй форум - можете его удалить или переименовать.
Это ваш сайт - поэтому делайте все, что пожелаете!
spadekevin
Сообщения: 8
Зарегистрирован: 20 июн 2018, 17:19

Any suggestions, other than ordering 4 mm Bowden Couplings?

Сообщение spadekevin » 06 авг 2018, 18:47

Hello,

I'm having some difficulty with the installation of the Run-out sensor on my N2-Plus (Early Production, Kickstarter Backer #42). Specifically, the 4 mm OD Bowden Tubes will not fit inside of the factory 6 mm OD Tubes that came with my printer. At best, I can push the 4 mm tube, 1-2 CM into the 6 mm tube; before it sticks and bends if any additional force is applied. I have some new, spare 6 mm tubes that Raise3D included in a batch of spare parts, along with the nylon tipped bed-screw replacements. I tried those as well; with similar results. I have even tried to use a diamond-coated file to chamfer the end of the 4 mm tube, without any improvement. Has anyone else experienced this, as well? Any suggestions, other than ordering 4 mm Bowden Couplings?

Please help.

I didn't find the right solution from the internet.

References:
http://forum.raise3d.com/viewtopic.php?t=8185
eCommerce software video

Thank you.
funnyjokes
Сообщения: 6
Зарегистрирован: 29 янв 2019, 07:24

Re: Any suggestions, other than ordering 4 mm Bowden Couplings?

Сообщение funnyjokes » 29 янв 2019, 07:27

The information you share is very useful. It is closely related to my work and has helped me grow. Thank you!
angry birds

Вернуться в «Второй форум»

Кто сейчас на конференции

Сейчас этот форум просматривают: нет зарегистрированных пользователей и 1 гость