Страница 1 из 1

How do I get the yark markers to print correctly???

Добавлено: 21 июл 2018, 13:01
spadekevin
Hello,

I have used the grid designer to enlarge and move the yard markers to the place they are on the field, bottom of the numbers at 11 steps off the side and tops at 14 off the sideline. I have turned off the markers for the "5's", just even numbered yardlines.

The yard markers print correctly (two printers, deskjet and laserjet) when printed in full page mode. They are also displayed correctly on the screen in the print preview page when zoom is not selected.
When "Zoom chart for largest printout" is selected, the yard markers are in the correct location but are less than one step in size (very small) on both the print out and on the display on the print-preview screen.

How do I get the yark markers to print correctly when "Zoom chart for largest printout" is selected?

Please help.

I didn't find the right solution from the internet.

References:
https://www.pyware.com/phpBB3/viewtopic.php?t=780
Wealth Management Solution Video

Thank you.

Re: How do I get the yark markers to print correctly???

Добавлено: 29 янв 2019, 07:33
funnyjokes
Really your post is really very good and I appreciate it. It’s hard to sort the good from the bad sometimes.You definitely put a new spin on a topic thats been written about for years.
light novel