Страница 1 из 1

Is that because of the unconstrained sketch in the first place....?

Добавлено: 21 июл 2018, 13:00
spadekevin
Hello,

Total Freecad noob here. I tried making a simple shape on freecad and had problems getting all the "degrees of freedom" locked down. So I ended up extruding the shape despite still having 2 degrees of freedom and exported it as an STL file. When I tried printing it on my Velleman K8200 printer, the layers did not line up and I got a screwed up print. Is that because of the unconstrained sketch in the first place....?

Please help.

I didn't find the right solution from the internet.

References:
https://forum.freecadweb.org/viewtopic.php?t=6674
HR Solution Video

Thank you.